Trackspec Autosports Porsche LWB 918 Seat Recliner Brackets Black -Anodized 992 GT3 Note * One set reclines one Seat These brackets raise your Porsche LWB seats approximately 1″ in the front, reclining the seat. One order provides brackets to adjust ONE seat. For owners who feel the stock seat position is too upright. Installation instructions are supplied. 6061-T6 Billet Aluminum Made in the USA One set reclines one seat. All mounting hardware is included. Raises your Porsche Carbon Fiber LWB seats approximately 1″ in the front For owners who feel the stock seat position is too upright. 992 GT3 kit contents One kit will work on either driver or passenger seat. x1 inner bracket x1 outer bracket x2 M6 bolts x2 M10 bolts x2 M10 washers x2 M10 nuts tools needed 3/8” ratchet E12 socket (3/8″ drive) 6mm Allen 8mm Allen 10mm wrench 16mm wrench 17mm wrench Blue Loctite or Medium strength thread locker Installation Instructions Step 1: Disconnect Battery Remove panel in trunk to access battery. Disconnect NEGATIVE (-) terminal using 10mm wrench. View fullsize Step 2: Remove Seat Bolts Use the E12 socket to remove all four seat bolts. Slide seat all the way back to access bolts 1&2. Slide seat all the way forward to access bolts 3&4 View fullsize Step 3: Unbolt Seatbelt Use the 17mm wrench to remove seat belt from seat. A plastic cap will need to be pulled off first. Step 4: Disconnect Yellow Plug Under the seat, disconnect the yellow plug by first pulling up on the black tab to unlock it. Drape a towel over the side sill to prevent scratches and carefully remove seat. View fullsize Step 5: Unbolt Pivoting Arm Remove bolt from the pivoting arm on both sides using the 16mm wrench and 8mm Allen. View fullsize Step 6: Install Seat Recliner Brackets Install recliner brackets as shown. Start threading the supplied M6 bolt into the bracket through the small hole in the seat rail, but do not tighten. On the right side, you will need to remove a wire harness clip. You can leave it loose or tie it off. Install supplied M10 bolt through seat rail and bracket. Secure with M10 washer and Nyloc nut , but do not tighten. Once both bolts are in place, tighten down the M6 bolt to 72 in lbs (or hand tight), then the M10 bolt to 30 ft lbs. Install pivoting arm to the riser with the shouldered part of the bolt on the plastic bushing. If installed correctly, the nut will be on the inside of the seat (opposite of how it was originally). Use medium strength thread locker on this nut and bolt and torque to 30 ft bs. Step 7: Reinstall Seat Follow directions in reverse to reinstall seat. NOTE: Hardware in install photos may look different than you were supplied. Hardware shown under “kit contents” at the top of this page are accurate.
